CNC plate shearing machine this machine equipment, our understanding and understanding of its should continue to go deep, so as to be able to fully understand this product as soon as possible. So next, we will carry out and carry out this work, mainly to explain its technical requirements.

Removal of hydraulic plate shears:

1, start the hydraulic shearing machine, so that the shearing Angle is adjusted to 1, 0°, so that the blade clearance is adjusted to the maximum value of 0, 48mm;

2. Close the machine and disconnect the total power supply of the hydraulic plate cutter after several rounds of up and down operation;

3. Remove the protective guardrail, pressure cylinder (pay attention to hydraulic oil overflow) and cover plate of the knife seat of the hydraulic plate shearer;

4, first remove the hydraulic shearing machine under the blade: loosen all the screws under the blade, with long wooden square in the back of the machine tool force against the next blade, to prevent the lower blade backward tipping or sliding, remove the screw on the blade, and then take out the next blade from the side of the hydraulic shearing machine;

5, then remove the hydraulic shearing machine on the blade: loosen all the screws on the blade, pad into two suitable wood between the table and the blade, and force the top of the blade, remove the screw on the blade, and then slowly loosen the pad into the wood, and take out the blade from the side of the hydraulic shearing machine.

Maintenance of hydraulic plate shears:

1. Check whether the belt, handle, knob and button are damaged regularly. If the wear is serious, it should be changed as soon as possible and reported to the spare parts supply.

2, every time before starting up according to the requirements of the lubricating oil chart timing, fixed point, quantitative add lubricating oil, oil should be clean without precipitation.

3. Lubricate the machine and clean the machine 10 minutes before work every day.

4. The lubricating oil in the motor bearing should be regularly changed and filled, and often check whether the local office of electrical appliances is normal and safe and reliable.

5, the machine must always maintain clean, unpainted local antirust grease.

6, regular maintenance switch, guarantee, handle, ensure its reliable office.